2011-2013 Land Cruiser · Service Manual Vehicle Interior

DIAGNOSTIC TROUBLE CODE CHART

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.

Transponder Key ECU Assembly 
DTC Code
Detection Item
Detection Enabling Condition (DTC Output Confirmation Operation)
See page
B2780
Push Switch / Key Unlock Warning Switch Malfunction
Insert the key into the ignition key cylinder.
Click here
B2784
Antenna Coil Open / Short
Insert the key into the ignition key cylinder.
Click here
B2793
Transponder Chip Malfunction
Insert the key into the ignition key cylinder.
Click here
B2794
Unmatched Encryption Code
Insert the key into the ignition key cylinder.
Click here
B2795
Unmatched Key Code
Insert the key into the ignition key cylinder.
Click here
B2796
No Communication in Immobiliser System
Insert the key into the ignition key cylinder.
Click here
B2797
Communication Malfunction No. 1
Insert the key into the ignition key cylinder.
Click here
B2798
Communication Malfunction No. 2
Insert the key into the ignition key cylinder.
Click here
ECM 
DTC Code
Detection Item
Detection Enabling Condition (DTC Output Confirmation Operation)
See page
B2799
Engine Immobiliser System Malfunction
Either condition is met:-
- Within 10 seconds of an engine start operation being performed an engine start operation refers to turning the ignition switch to ON with the shift lever in P and the brake pedal depressed*1, or the shift lever in N and the brake pedal and clutch pedal depressed*2. If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds).
- 10 seconds after the ignition switch is turned to ON after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the ignition switch being turned to ON, and DTCs are stored after 6 seconds).
Click here
B279A
Theft Deterrent System Communication Line High Fixation
Turn the ignition switch to ON and wait 6 seconds.
Click here
B279C
Theft Deterrent System Presence Detection
Check for DTCs.
Click here
  1. *1: for Automatic Transmission
  2. *2: for Manual Transmission
← DATA LIST / ACTIVE TEST (from Sep 2011)DIAGNOSTIC TROUBLE CODE CHART (from Jan 2012) →