B2793 Transponder Chip Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
Also covers:
- B2794 Unmatched Encryption Code
- B2797 Communication Malfunction No. 1
- B2798 Communication Malfunction No. 2
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
- DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.
- DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.
- DTC B2797 is stored when a key with a Bcc malfunction is inserted into the ignition key cylinder.
- DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.
| DTC Code |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
| B2793 |
A transponder chip malfunction (1 trip detection logic*). |
|
Insert the key into the ignition key cylinder. |
| B2794 |
A key with an incomplete key code is inserted into the ignition key cylinder (1 trip detection logic*). |
||
| B2797 |
A key with a Bcc malfunction is inserted into the ignition key cylinder (1 trip detection logic*). |
||
| B2798 |
Key code identification cannot be completed within the specified time (1 trip detection logic*). |
- *: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected |
Fail-safe Operation When Malfunction Detected |
| Engine cannot be started |
- |
| DTC Code |
Data List and Active Test |
| B2793 |
Abnormal Status |
| B2794 |
Different Encrypt Code |
| B2797 |
Bcc Malfunction |
| B2798 |
Frame Error |
INSPECTION PROCEDURE
- NOTICE:
- When replacing the key and transponder key ECU assembly, refer to the Service Bulletin.
- After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
- When replacing the key and transponder key ECU assembly, refer to the Service Bulletin.
| 1. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Insert and remove each registered key one at a time, and check for DTCs each time (Click here).
- HINT:
- Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
- If a DTC is output, clear the DTCs before checking the next key.
- Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
- OK:
- DTCs B2793, B2974, B2797 and B2798 are not output.
Result Result
Proceed to
OK
A
NG (all keys)
B
NG (any key)
C
|
|
||||
|
|
||||
| A | ||
| ||
| 3. CHECK CONNECTION OF CONNECTOR |
Check that the connectors are properly connected to the transponder key amplifier.
Check that the engine starts with the key.
- OK:
- Engine starts.
|
|
||||
| OK | ||
| ||
| 4. REPLACE TRANSPONDER KEY AMPLIFIER |
Clear the DTCs. (Click here).
Replace the transponder key amplifier (Click here).
Check that the engine starts with the key.
- OK:
- Engine starts.
|
|
||||
| OK | ||
| ||
