2011-2013 Land Cruiser · Service Manual Vehicle Exterior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Sep 2011

HINT:
  1. Use these procedures to troubleshoot the sliding roof system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK LIN COMMUNICATION SYSTEM*
    1. Using the intelligent tester, check if the LIN communication system is functioning normally.

      ResultĀ 
      Result
      Proceed to
      LIN communication system DTC is not output
      A
      LIN communication system DTC is output
      B


    B.
    A

    4.PROBLEM SYMPTOMS TABLE
    1. Refer to the problem symptoms table (Click here).

      ResultĀ 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    3. Data List / Active Test (Click here).

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.INITIALIZATION
      1. Initialization (Click here).

      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Sep 2011)OPERATION CHECK (from Sep 2011) →