2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Sliding Roof ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ECU power source circuit.

WIRING DIAGRAM

B156647E02

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (IGNITION SWITCH SIGNAL)
  1. Use the Data List to check if the ignition switch signal is functioning properly (Click here).

Sliding Roof 
Tester Display
Test Part
Control Range
Diagnostic Note
Ignition (MPX)
Ignition switch signal (MPX signal)/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Ignition (Direct Signal)
Ignition switch signal/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-

OK:
The intelligent tester displays as shown in the table according to the operation of each switch.



NG
Go to step 2
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (Click here)

2. INSPECT FUSE (S/ROOF, ECU-IG NO. 2)
  1. Remove the S/ROOF and ECU-IG NO. 2 fuses from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S/ROOF fuse
    Always
    Below 1 Ω
    ECU-IG NO. 2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (SLIDING ROOF DRIVE GEAR - BATTERY AND BODY GROUND)

  1. B130117E08
    Disconnect the R5 drive gear connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R5-2 (E) - Body ground
    Always
    Below 1 Ω
    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R5-1 (B) - Body ground
    Always
    11 to 14 V
    R5-5 (IG) - Body ground
    Engine switch off
    Below 1 V
    R5-5 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (Click here)


← Sliding Roof Control Switch Circuit (from Sep 2011)COMPONENTS (from Sep 2011) →