2011-2013 Land Cruiser · Service Manual Vehicle Exterior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

HINT:
  1. Use the following procedure to troubleshoot the wiper and washer system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
      NEXT

      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage with the ignition switch off.

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT

      4.PROBLEM SYMPTOMS TABLE
      1. Refer to the Problem Symptoms Table (Click here).

      2. Result 
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Table
        B

      B.
      A

      5.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here).

      2. Terminals of ECU (Click here).

      3. Inspection.

      4. On-vehicle inspection.

      NEXT

      6.ADJUST, REPAIR OR REPLACE
        NEXT

        7.CONFIRMATION TEST
          NEXT

          ← SYSTEM DESCRIPTION (from Jan 2012)PROBLEM SYMPTOMS TABLE (Sep 2011 – Dec 2011) →