2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT BACK DOOR LOCK ASSEMBLY
  1. Set the back door lock to the full-latch position.

  1. Apply battery voltage to the door motor terminals and check the operation of the door lock motor.

    B183291E01

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 2 (ACT+)
    Battery negative (-) → 1 (ACT-)
    Moves to open-latch position

    1. If the result is not as specified, replace the back door lock assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (ACT-) - 3 (+)
    Open-latch
    Below 1 Ω
    1 (ACT-) - 3 (+)
    Full-latch
    10 kΩ or higher

    1. If the result is not as specified, replace the back door lock assembly.

← REMOVAL (from Jan 2012)INSPECTION (from Jan 2012) →