INSTALLATION
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. INSTALL SKID CONTROL BUZZER ASSEMBLY (for LHD) |
Connect the buzzer connector.

- NOTICE:
- Securely connect the connector.
Attach the clamp to install the buzzer.
- NOTICE:
- Securely insert the clamp into the bracket.
- If the buzzer is dropped, replace it.
- Securely insert the clamp into the bracket.
| 2. INSTALL SKID CONTROL BUZZER ASSEMBLY (for RHD) |
Connect the buzzer connector.

- NOTICE:
- Securely connect the connector.
Attach the clamp to install the buzzer.
- NOTICE:
- Securely insert the clamp into the bracket.
- If the buzzer is dropped, replace it.
- Securely insert the clamp into the bracket.
| 3. INSTALL NO. 1 SWITCH HOLE BASE |
![]() ![]() |
Connect the connectors.
Attach the 4 claws to install the No. 1 switch hole base.
| 4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL |
Connect the connectors.
for Automatic Air Conditioning System:

Attach the 2 claws to install the room temperature sensor.
Attach the 2 claws to connect the 2 control cables.

w/ Driver Side Knee Airbag:
Attach the 16 claws to install the lower No. 1 instrument panel finish panel.
Install the 2 bolts.


w/o Driver Side Knee Airbag:
Attach the 9 claws to install the lower No. 1 instrument panel finish panel.
Install the 2 bolts.


Attach the 2 claws to close the hole cover.

| 5. INSTALL COWL SIDE TRIM BOARD |
![]() ![]() |
Attach the 2 clips to install the cowl side trim board.
Install the cap nut.
| 6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() ![]() |
Connect the connectors.
Attach the 3 claws to install the No. 1 instrument panel under cover.
Install the 2 screws.
| 7. INSTALL FRONT DOOR SCUFF PLATE |
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



