2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Reverse Signal Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The display and navigation module display receives a reverse signal from the park/neutral position switch and information about the navigation antenna assembly, and then adjusts the vehicle position on the navigation display.

WIRING DIAGRAM

E194877E03

INSPECTION PROCEDURE


1. CHECK REVERSE SIGNAL (DISPLAY CHECK MODE)

  1. E181227
    Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever operation.

    OK:
    Condition
    Display
    Shift lever in R
    ON
    Shift lever in any position except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT DISPLAY AND NAVIGATION MODULE DISPLAY

  1. E194871E07
    Disconnect the F64 display and navigation module display connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F64-16 (REV) - Body ground
    Engine switch on (IG)
    Shift lever in R
    11 to 14 V
    F64-16 (REV) - Body ground
    Engine switch on (IG)
    Shift lever in any position except R
    Below 1 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Display and Navigation Module Display)



NG
Go to step 3
OK

REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)

3. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY - PNP SWITCH)
  1. Disconnect the F64 display and navigation module display connector.

  1. Disconnect the C24 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F64-16 (REV) - C24-1 (RL)
    Always
    Below 1 Ω
    F64-16 (REV) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    NG
    A
    OK (for AB60F Automatic Transaxle)
    B
    OK (for AB750F Automatic Transaxle)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← AVC-LAN Circuit (Sep 2011 – Dec 2011)DVD Image Signal Circuit between Radio Receiver and Navigation ECU (Sep 2011 – Dec 2011) →