Back Door Entry Lock Function does not Operate
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
If the back door entry lock function does not operate but the back door open function operates, the communication line between the vehicle and electrical key transmitter is normal. As a faulty part, the entry lock switch circuit (certification ECU (smart key ECU assembly) → back door opener switch) can be considered.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Before performing the inspection, check that there are no problems related to "CAN COMMUNICATION SYSTEM" and "LIN COMMUNICATION SYSTEM".
| 1. CHECK POWER DOOR LOCK OPERATION |
When the door control switch of the master switch assembly is operated, check that the locked doors unlock.
- OK:
- Door locks operate normally.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (DOOR LOCK POSITION SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Back Lock Pos switch
Back door lock position switch signal / ON or OFF
ON: Back door is unlocked
OFF: Back door is locked
-
- OK:
- On the intelligent tester screen, the display changes between ON and OFF as shown in the chart above.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (BACK DOOR LOCK SWITCH) |
Using the intelligent tester, read the Data List.
Entry & Start Tester Display
Measurement Item/Display
Normal Condition
Diagnostic Note
Tr/B-Door Lock SW
Back door lock switch / ON or OFF
ON: Back door lock switch is pushed
OFF: Back door lock switch is not pushed
-
- OK:
- "ON" (switch is pushed) or "OFF" (switch is not pushed) appears on the screen.
|
|
||||
| OK | ||
| ||
| 4. CHECK BACK DOOR OPENER SWITCH |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 (UL) - 2 (L)
Lock switch pushed
Below 1 Ω
1 (UL) - 2 (L)
Lock switch not pushed
10 kΩ or higher
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - BACK DOOR OPENER SWITCH) |
Disconnect the E29 ECU connector.

Disconnect the S7 switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E29-7 (TSW5) - S7-1 (UL)
Always
Below 1 Ω
E29-7 (TSW5) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
