2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2274 ACC Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC is stored when a malfunction occurs in the ACCD output circuit, which is between the ACC relay actuation circuit inside the main body ECU and the ACC relay.
DTC Code
Detection Condition
Trouble Area
B2274
The ACC relay actuation circuit inside the main body ECU or other related circuit is malfunctioning.
  1. Main body ECU
  2. Harness or connector

WIRING DIAGRAM

C164716E05

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (ACC RELAY MONITOR)
  1. Use the Data List to check if the ACC relay is functioning properly.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ACC Relay Monitor
    ACC relay monitor/ON or OFF
    ON: Engine switch on (IG)
    OFF: Engine switch off
    -

    OK:
    When the engine switch is turned on (IG), ON is displayed on the intelligent tester.



NG
Go to step 3
OK


2. CHECK WHETHER DTC OUTPUT RECURS
  1. Clear the DTCs (Click here).

  1. Turn the engine switch on (IG), wait at least 10 seconds, and check whether DTC B2274 is output.

    Result 
    Result
    Proceed to
    No DTC output
    A
    DTC B2274 output
    B



B
REPLACE MAIN BODY ECU
A

USE SIMULATION METHOD TO CHECK (Click here)

3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND)
A175399E02
  1. Disconnect the E1, 2A and 2D main body ECU connectors.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2A-1 - Body ground
    Always
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-22 (ACCD) - 2D-45
    Always
    Below 1 Ω
    2D-62 (GND2) - Body ground
    Always
    Below 1 Ω
    E1-22 (ACCD) or 2D-45 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← B2274 ACC Monitor Malfunction (Sep 2011 – Dec 2011)B2275 STSW Monitor Malfunction (Sep 2011 – Dec 2011) →