2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2275 STSW Monitor Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC is stored when the engine start request signal circuit inside the main body ECU is open or shorted.
DTC Code
Detection Condition
Trouble Area
B2275
The engine start request signal circuit inside the main body ECU or other related circuit is malfunctioning.
  1. Main body ECU
  1. ECM
  1. Harness or connector

WIRING DIAGRAM

C162997E10

INSPECTION PROCEDURE


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Clear the DTCs (Click here).

  1. Depress the brake pedal (for A/T) or clutch pedal (for M/T) with the engine switch on (IG), wait at least 15 seconds, and check whether DTC B2275 is output.

    Result 
    Result
    Proceed to
    DTC B2275 output
    A
    No DTC output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)
A175400E02
  1. Disconnect the E4 main body ECU connector.

  1. Disconnect the A38 (for LHD) or A52 (for RHD) ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-4 (STSW) - A38-14 (STSW)*1
    E4-4 (STSW) - A52-14 (STSW)*2
    Always
    Below 1 Ω
    E4-4 (STSW) or A38-14 (STSW) - Body ground*1
    E4-4 (STSW) or A52-14 (STSW) - Body ground*2
    Always
    10 kΩ or higher

    HINT:
    *1: for LHD
    *2: for RHD



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MAIN BODY ECU
C164808E02
  1. Measure the voltage according to the value(s) in the table below.

    HINT:
    The voltage is generated at terminal STSW for 0.3 seconds when the engine cranks.

    Standard Voltage (for A/T):
    Tester Connection
    Condition
    Specified Condition
    E4-4 (STSW) - Body ground
    Brake pedal depressed with shift lever in P, engine switch pushed once
    11 to 14 V

    Standard Voltage (for M/T):
    Tester Connection
    Condition
    Specified Condition
    E4-4 (STSW) - Body ground
    Clutch pedal depressed, engine switch pushed once
    11 to 14 V

    Result 
    Result
    Proceed to
    Outside specified range
    A
    Within specified range (for 1GR-FE)
    B
    Within specified range (for 2UZ-FE)
    C
    Within specified range (for 3UR-FE)
    D
    Within specified range (for 1VD-FTV)
    E



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)

E
REPLACE ECM (Click here)
A

REPLACE MAIN BODY ECU


← B2274 ACC Monitor Malfunction (from Jan 2012)B2275 STSW Monitor Malfunction (from Jan 2012) →