2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011


INSPECT AIR PUMP

A158401E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    0.4 to 1.0 Ω
    1 - Body ground
    Always
    10 kΩ or higher
    2 - Body ground

    If the result is not as specified, replace the air pump.

  1. A158402E01
    Check operation of the air pump.

    1. Check that air does not flow from port A to port B.
      If the result is not as specified, replace the air pump.

    2. A158400E01
      Apply battery voltage to the connector, and check the air pump operation.

      NOTICE:
      1. Do not operate the air pump continuously for 2 minutes or more.
      2. When operating the air pump, wait 5 minutes until the pump has cooled down between each operation. If the pump has not cooled down sufficiently, the motor will burn out.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 5
      Air flows from port A to port B

      If the result is not as specified, replace the air pump.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →