2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT PURGE VSV

A148341E07
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    23 to 26 Ω
    1 - VSV body ground
    Always
    10 kΩ or higher
    2 - VSV body ground
    10 kΩ or higher

    If the result is not as specified, replace the purge VSV.

  1. Check the operation of the purge VSV.

    1. A148342E09
      Check that air does not flow from port F when air is applied to port E.
      Text in Illustration 
      *a
      Does not flow
      V100135
      Air

    2. A148343E09
      Apply battery voltage to the connector, and check the VSV operation.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Air flows from port E to port F

      Text in Illustration 
      V100135
      Air
      If the result is not as specified, replace the purge VSV.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →