INSPECTION
Inspection · Vehicles built Sep 2011 – Dec 2011
| INSPECT AIR SWITCHING VALVE ASSEMBLY |
Measure the resistance of the valve.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1- 2
20°C (68°F)
4.5 to 5.5 Ω
1 - Body ground
Always
1 MΩ or higher
2 - Body ground
Always
1 MΩ or higher
Check the valve operation.
Blow air into port A and check that air is not discharged from port B.

Apply battery voltage across the terminals.

Blow air into port A and check that air is discharged from port B.
If the result is not as specified, replace the air switching valve assembly.
| INSPECT NO. 1 AIR SWITCHING VALVE ASSEMBLY |
Blow air into port B and check that air is not discharged from port C.

Apply vacuum of 33 kPa (250 mmHg, 9.83 in.Hg) to port A, blow air into port B and check that air is discharged from port C.

If the result is not as specified, replace the No. 1 air switching valve assembly.
| INSPECT NO. 2 AIR SWITCHING VALVE ASSEMBLY |
Blow air into port B and check that air is not discharged from port C.

Apply vacuum of 33 kPa (250 mmHg, 9.83 in.Hg) to port A, blow air into port B and check that air is discharged from port C.

If the result is not as specified, replace the No. 2 air switching valve assembly.
