2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. REMOVE FRONT FENDER APRON SEAL REAR LH

  1. A177005
    Using a clip remover, remove the 4 clips and fender apron seal.


2. REMOVE FRONT FENDER APRON SEAL REAR RH

  1. A177002
    Using a clip remover, remove the 4 clips and fender apron seal.


3. REMOVE INTAKE MANIFOLD
  1. Remove the intake manifold (Click here).


4. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY

  1. A179558
    Disconnect the connector.

  1. Disconnect the wire harness clamp from the water by-pass pipe.

  1. Disconnect the 2 vacuum switching valve hoses from the water by-pass pipe clamp.

  1. Remove the bolt.

  1. Pull out the water by-pass pipe.

  1. Remove the O-ring from the water by-pass pipe.


5. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE

  1. A179559
    Remove the No. 2 air injection system hose from the rear water by-pass joint and air switching valve.


6. REMOVE AIR SWITCHING VALVE ASSEMBLY

  1. A179562
    Disconnect the air pressure sensor connector.

  1. Disconnect the air switching valve connector.

  1. Remove the vacuum hose from the air pressure sensor and air switching valve.

  1. Remove the 2 bolts and air pressure sensor from the air switching valve.

  1. A179563
    Remove the 2 bolts and air switching valve from the air pump bracket.

  1. Remove the air switching valve from the No. 1 air injection system hose.


7. DISCONNECT NO. 1 WATER BY-PASS PIPE (w/o Air Cooled Transmission Oil Cooler)

  1. A175115
    Remove the 2 bolts and disconnect the water by-pass pipe from the cylinder head cover RH.


8. REMOVE AIR TUBE SUB-ASSEMBLY RH

  1. A179565
    Remove the 2 bolts, 2 nuts and air tube sub-assembly.

  1. Remove the 2 gaskets.


9. REMOVE NO. 3 AIR TUBE

  1. A179564
    Remove the 2 bolts, 2 nuts and No. 3 air tube.

  1. Remove the 2 gaskets.


10. REMOVE NO. 2 AIR SWITCHING VALVE ASSEMBLY

  1. A181856
    Remove the vacuum switching valve hose from the No. 2 air switching valve.

  1. Remove the 2 bolts, gasket and No. 2 air switching valve from the rear water by-pass joint.


11. REMOVE NO. 1 AIR SWITCHING VALVE ASSEMBLY

  1. A182349
    Remove the vacuum switching valve hose from the No. 1 air switching valve.

  1. Remove the 2 bolts, gasket and No. 1 air switching valve from the rear water by-pass joint.

← ON-VEHICLE INSPECTION (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →