2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
(Click here)

2. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
(Click here)

3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

  1. A224775E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A224777
    Remove the 8 bolts, rear spacer, drive plate and front spacer.

    NOTICE:
    Do not reuse the bolts.


4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

C173303E01
  1. Put matchmarks on the clutch cover and flywheel.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts, and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.


5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.


6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

  1. A224775E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A224776
    Remove the 8 bolts and flywheel.

    NOTICE:
    Do not reuse the bolts.


7. REMOVE REAR CRANKSHAFT OIL SEAL

  1. A076328E03
    Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *1
    Cut Position

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole or crankshaft.

    HINT:
    Tape the screwdriver tip before use.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →