2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. INSTALL OIL PUMP SEAL

  1. A004864E03
    Apply MP grease to the lip of a new oil seal.

    NOTICE:
    1. Do not allow foreign matter to contact the lip of the oil seal.
    2. Do not allow MP grease to contact the dust seal.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the oil pump body edge.

    SST
    09316-60011   (09316-00011)

    NOTICE:
    1. Keep the lip of the oil seal free from foreign matter.
    2. Do not tap the oil seal at an angle.


2. INSTALL CRANKSHAFT TIMING PULLEY

  1. A004446E03
    Align the timing pulley set key with the key groove of the pulley.

  1. Using SST and a hammer, tap in the timing pulley with the flange side facing inward.

    SST
    09223-46011  


3. INSTALL TIMING BELT
  1. Install the timing belt (Click here).


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← REMOVAL (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →