Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
2.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.
3.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
4.
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
Remove the 10 bolts and under cover.
5.
DRAIN ENGINE COOLANT
CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Loosen the radiator drain cock plug.
Remove the radiator reservoir cap to drain the coolant in the radiator.
Loosen the oil filter bracket drain cock plug to drain the coolant in the engine.
Tighten the radiator drain cock plug by hand.
Tighten the oil filter bracket drain cock plug.
Torque:
13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
6.
REMOVE FRONT FENDER APRON SEAL FRONT RH
Remove the 3 clips and front fender apron seal front RH.
7.
REMOVE FRONT FENDER APRON SEAL REAR RH
Remove the 4 clips and front fender apron seal rear RH.
8.
REMOVE V-RIBBED BELT (w/ Viscous Heater)
Loosen the lock nut and turn the bolt counterclockwise.
Remove the V-ribbed belt.
9.
REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)
Remove the bolt, cover, No. 1 idler pulley and collar.
10.
REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)
Remove the nut and No. 3 idler pulley.
11.
REMOVE V-RIBBED BELT
Using a wrench to the V-ribbed belt tensioner bracket, turn the wrench clockwise and remove the V-ribbed belt.