1.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Remove the 3 bolts and screw.
Loosen the clip and remove the front fender splash shield LH.
2.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
Remove the 3 bolts and 2 screws.
Loosen the clip and remove the front fender splash shield RH.
3.
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
Remove the 10 bolts and No. 1 engine under cover.
4.
DRAIN ENGINE COOLANT
CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Loosen the radiator drain cock plug.
Remove the radiator reservoir cap to drain the coolant in the radiator.
Loosen the oil filter bracket drain cock plug to drain the coolant in the engine.
Tighten the radiator drain cock plug by hand.
Tighten the oil filter bracket drain cock plug.
Torque:
13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
5.
REMOVE V-RIBBED BELT (w/ Viscous Heater)
Loosen the lock nut and turn the bolt counterclockwise.
Remove the V-ribbed belt.
6.
REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)
Remove the bolt, cover, No. 1 idler pulley and collar.
7.
REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)
Remove the nut and No. 3 idler pulley.
8.
REMOVE V-RIBBED BELT
Using a wrench to the V-ribbed belt tensioner bracket, turn the wrench clockwise and remove the V-ribbed belt.