2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. REMOVE STARTER YOKE ASSEMBLY

  1. A159744
    Remove the nut and disconnect the lead wire from terminal C.

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke and the armature together.

  1. Remove the O-ring from the starter yoke.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A074097E01
    Remove the 2 screws and magnet starter switch.

  1. A164761E01
    Remove the return spring, idler gear, clutch roller, retainer and starter clutch from the starter housing.

  1. A115020
    Using a magnetic finger, remove the steel ball from the clutch shaft hole.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A164437
    Remove the 2 screws and end frame from the starter yoke.

  1. Remove the O-ring from the starter yoke.

  1. A115022
    Using a screwdriver, hold the spring back and disconnect the 4 brushes from the brush holder.

  1. Remove the brush holder from the armature.


4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →