2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH
  1. Connect the connector.

  1. Install the light with the 3 screws.


2. INSTALL OUTER MIRROR COVER LH

  1. Install the outer mirror cover.

    1. B302369E01
      Insert the rib on the outer edge of the cover into the groove of the mirror body.

      NOTICE:
      Do not scratch the turn light.

      Text in Illustration 
      *1
      Rib

    2. B302371
      While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.

  1. B302372
    Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.

  1. Check that there is no gap between the cover and mirror body.

    HINT:
    If there is a gap between the cover and body, noise will occur during driving.


3. INSTALL OUTER MIRROR LH

  1. Install the outer mirror cover.

    1. B302369E01
      Insert the rib on the outer edge of the cover into the groove of the mirror body.

      NOTICE:
      Do not scratch the turn light.

      Text in Illustration 
      *1
      Rib

    2. B302371
      While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.

  1. B302372
    Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.

  1. Check that there is no gap between the cover and mirror body.

    HINT:
    If there is a gap between the cover and body, noise will occur during driving.


4. INSTALL OUTER REAR VIEW MIRROR LH
(Click here)
← INSPECTION (from Jan 2012)COMPONENTS (Sep 2011 – Dec 2011) →