2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. DISCHARGE FUEL SYSTEM PRESSURE
  1. Discharge the fuel system pressure (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE INTAKE MANIFOLD
  1. Remove the intake manifold (Click here).


4. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY

  1. A179558
    Disconnect the connector.

  1. Disconnect the wire harness clamp from the water by-pass pipe.

  1. Disconnect the 2 vacuum switching valve hoses from the water by-pass pipe clamp.

  1. Remove the bolt.

  1. Pull out the water by-pass pipe.

  1. Remove the O-ring from the water by-pass pipe.


5. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE

  1. A179559
    Remove the No. 2 air injection system hose from the rear water by-pass joint and air switching valve.


6. REMOVE AIR PUMP WITH BRACKET AND AIR SWITCHING VALVE

  1. A179560
    Disconnect the air switching valve connector.

  1. Disconnect the air pressure sensor connector.

  1. Remove the 2 bolts, 2 nuts and air pump with bracket.


7. REMOVE KNOCK SENSOR

  1. A175759
    Disconnect the 2 sensor connectors.

  1. Remove the 2 nuts and 2 sensors.

← COMPONENTS (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →