2011-2013 Land Cruiser · Service Manual Steering

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. PRECAUTION

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A267633E01
    Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    Hook


4. REMOVE FAN AND GENERATOR V BELT

  1. A217571
    While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar with a diameter of 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.


5. DRAIN POWER STEERING FLUID

6. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

C172779
  1. Disconnect the connector.

  1. Detach the wire harness clamp from the bracket.


7. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

C172780
  1. Slide the clip and disconnect the No.1 oil reservoir to pump hose from the vane pump.


8. DISCONNECT PRESSURE FEED TUBE

  1. C172778
    Remove the union bolt and disconnect the pressure feed tube.

  1. Remove the gasket.


9. REMOVE VANE PUMP ASSEMBLY

F051260E01
  1. Remove the 2 bolts and vane pump.

← REMOVAL (Sep 2011 – Dec 2011)DISASSEMBLY (from Sep 2011) →