2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Engine Switch Illumination Circuit

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

The engine switch illumination is controlled by the main body ECU. The operation and condition of this control are described below (Light control switch is OFF).
Operation
Condition
Fade in
When any of the following conditions is met, the engine switch illumination fades in.
  1. The key enters any actuation area around the doors when the engine switch is off and all the doors are closed.
  2. Any door is opened.
  3. Any door is unlocked when the engine switch is off and all the doors are closed.
  4. The engine switch is turned from on (ACC) to off when all the doors are closed.
Fade out immediately
When either of the following conditions is met, the engine switch illumination fades out.
  1. The engine switch is turned from off to on (ACC) or on (IG) when all the doors are closed.
  2. All the doors are locked when the engine switch is off.
Illuminate for approximately 15 seconds, and then fade out
All the doors are closed when the engine switch is off.

WIRING DIAGRAM

E159828E01

INSPECTION PROCEDURE


1. INSPECT ENGINE SWITCH
A109252E35
  1. Remove the engine switch (Click here).

  1. Apply battery voltage to the engine switch.

  1. Check that the illumination comes on.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 5 (GND)
    Engine switch illumination comes on



NG
REPLACE ENGINE SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND)

  1. E157459E01
    Disconnect the E1 ECU connector.

  1. Disconnect the E18 engine switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-11 (SWIL) - E1-25 (SWIL)
    Always
    Below 1 Ω
    E18-5 (GND) - Body ground
    E1-11 (SWIL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← Door Courtesy Light Circuit (from Jan 2012)License Plate Light Circuit (from Sep 2011) →