2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P0657 Actuator Supply Voltage Circuit / Open

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage usually is 0 V when the engine switch is turned off. If the output voltage is higher than 7 V when the engine switch is turned off, the ECM will illuminate the MIL and store DTC(s) when the engine switch is turned on (IG).
DTC Code
DTC Detection Condition
Trouble Area
P0657
A throttle actuator power supply error.
ECM

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the engine switch on (IG) for 10 seconds.

  1. Turn the engine switch off.

  1. Turn the engine switch on (IG).

  1. Check DTC.

    OK:
    P0657 is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P0657 Actuator Supply Voltage Circuit / Open (Sep 2011 – Dec 2011)P0660 Intake Manifold Tuning Valve Control Circuit / Open (Bank 1) (Sep 2011 – Dec 2011) →