P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The ECM detects the signal from the transfer L4 position switch.This DTC indicates that the transfer L4 position switch remains on.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P2772 |
The transfer L4 position switch remains on while the vehicle is running under the following conditions for 1.8 sec. or more (1 trip detection logic): (a) The output shaft speed is between 1000 and 3000 rpm. (b) The transfer position switch is in H4. |
|
MONITOR DESCRIPTION
The ECM monitors the transfer-case L4 position switch to determine when the transfer-case L4 gears are engaged. If the transfer-case L4 gears remain engaged under the following conditions, the ECM will conclude that there is a malfunction of the L4 position switch, illuminate the MIL and store the DTC:- L4 switch indicated that the L4 transfer-case gears are engaged.
- The transfer-case shifter is in the "H4" position.
- The transfer-case output shaft rpm is between 1000 and 3000 rpm.
- The specified time period has elapsed.
WIRING DIAGRAM
Refer to DTC P0818 (Click here).INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND) |
Disconnect the A27 four wheel drive control ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A27-21 (L4) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM) |
Disconnect the A38 ECM connector.

Disconnect the A27 four wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A38-21 (L4) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
