2011-2013 Land Cruiser · Service Manual Drivetrain

P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The ECM detects the signal from the transfer L4 position switch.
This DTC indicates that the transfer L4 position switch remains on.
DTC Code
DTC Detection Condition
Trouble Area
P2772
The transfer L4 position switch remains on while the vehicle is running under the following conditions for 1.8 sec. or more (1 trip detection logic):
(a) The output shaft speed is between 1000 and 3000 rpm.
(b) The transfer position switch is in H4.
  1. Short in transfer L4 position switch circuit
  2. Four wheel drive control ECU
  3. ECM

MONITOR DESCRIPTION

The ECM monitors the transfer-case L4 position switch to determine when the transfer-case L4 gears are engaged. If the L4 switch indicates that the transfer-case L4 gears remain engaged under the following conditions, the ECM will conclude that there is a malfunction of the L4 position switch, illuminate the MIL and store the DTC:
  1. The transfer-case shifter is in the "H4" position.
  2. The transfer-case output shaft rpm is between 1000 and 3000 rpm.
  3. The specified time period has elapsed.

WIRING DIAGRAM

C160106E08

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)

  1. C209926E19
    Disconnect the four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-21 (L4) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Four Wheel Drive Control ECU)



NG
Go to step 2
OK

GO TO TRANSFER SYSTEM INSPECTION (Click here)

2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM)

  1. C219460E08
    Disconnect the ECM connector.

  1. Disconnect the A27 four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A38-21 (L4) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance (Sep 2011 – Dec 2011)Transmission Control Switch Circuit (Sep 2011 – Dec 2011) →