Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)
HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
HINT:
Use these procedures to troubleshoot the air conditioning system.
*: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result
Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD)
B
CAN DTC is output (for RHD)
C
4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
Use the intelligent tester to check if the LIN communication system is functioning normally.
Result
Result
Proceed to
LIN DTC is not output
A
LIN DTC is output
B
B.
A
Check for DTCs (Click here ).
Clear the DTC (Click here ).
Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the conditions indicated by the DTC. Then recheck for DTCs.
Result
Result
Proceed to
DTC is not output
A
DTC is output
B
B.
A
Refer to the Problem Symptoms Table (Click here ).
Result
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
B.
A
7.OVERALL ANALYSIS AND TROUBLESHOOTING*
Terminals of ECU (Click here )
Data List/Active Test (Click here )
Actuator Check (Click here )
On-vehicle Inspection
Inspection
NEXT
8.ADJUST, REPAIR OR REPLACE
NEXT
NEXT