2011-2013 Land Cruiser · Service Manual Vehicle Interior

B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side)

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The front air mix damper servo motor (for front passenger side) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the front air mix damper (for front passenger side) to any position. As a result, the amount of air that has passed through the evaporator and is passing through the heater core is adjusted, and the temperature of the air blowing toward the front passenger side is controlled.

HINT:
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.

DTC Code
DTC Detection Condition
Trouble Area
B1441/41
The air mix damper position does not change even if the air conditioning amplifier assembly operates the air mix damper servo motor.
  1. Air mix damper servo motor (for front passenger side)
  2. Air conditioning harness assembly
  3. Air conditioning amplifier assembly

WIRING DIAGRAM

E161749E01
E161749E02

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (AIR MIX DAMPER SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Mix Servo Targ Pulse (P)
    Air mix damper servo motor (for front passenger side) target pulse /
    Min.: 8, Max.: 90 (for LHD)
    Min.: 8, Max.: 90 (for RHD)
    for LHD
    1. MAX COOL: 8 (pulse)
    2. MAX HOT: 90 (pulse)
    for RHD
    1. MAX COOL: 90 (pulse)
    2. MAX HOT: 8 (pulse)
    -

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

2. CHECK AIR MIX DAMPER SERVO MOTOR (OPERATION)
  1. for LHD

    1. Replace the air mix damper servo motor (for front passenger side) (Click here).

  1. for RHD

    1. Replace the air mix damper servo motor (for front passenger side) (Click here).

      HINT:
      Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1441 is not output.

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG (for LHD)
    C
    NG (for RHD)
    D



B
REPLACE AIR MIX DAMPER SERVO MOTOR (Click here)

C
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)

D
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)
A

REPLACE AIR MIX DAMPER SERVO MOTOR (Click here)


← B1429/29 Rear Air Foot Duct Sensor Circuit on Front Passenger Side (from Jan 2012)B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side) (from Jan 2012) →