2011-2013 Land Cruiser · Service Manual Vehicle Interior

Rear Air Conditioning Control Panel Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit consists of the No. 2 air conditioning control assembly* and the air conditioning amplifier assembly. When the No. 2 air conditioning control assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the No. 2 air conditioning control assembly is operated.

HINT:
*: w/ Rear Heater


WIRING DIAGRAM

E157369E11

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG NO. 2)
  1. Remove the ECU-IG NO. 2 fuse from the cowl side junction block LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG NO. 2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (NO. 2 AIR CONDITIONING CONTROL - BODY GROUND AND BATTERY)
E127597E04
  1. Disconnect the E55 No. 2 air conditioning control assembly connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E55-1 (E) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E55-6 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - NO. 2 AIR CONDITIONING CONTROL)
E157371E01
  1. Disconnect the E55 No. 2 air conditioning control assembly connector.

  1. Disconnect the E36 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E36-21 (RLIN) - E55-4 (RLIN)
    Always
    Below 1 Ω
    E55-4 (RLIN) - Body ground
    Always
    10 kΩ or higher
    E36-21 (RLIN) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK NO. 2 AIR CONDITIONING CONTROL ASSEMBLY (OPERATION)
  1. Replace the No. 2 air conditioning control assembly with a new or properly functioning one (Click here).

  1. Operate the No. 2 air conditioning control assembly to check that it functions properly.

    OK:
    No. 2 air conditioning control assembly function operates normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE NO. 2 AIR CONDITIONING CONTROL ASSEMBLY (Click here)


← Air Conditioning Compressor Magnetic Clutch Circuit (from Jan 2012)Rear Air Conditioning Control Panel Circuit (from Jan 2012) →