2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT CRUISE CONTROL MAIN SWITCH ASSEMBLY

  1. Measure the resistance (for vehicles without vehicle-to-vehicle distance control mode).

    E155225E02

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 (ECC) - 3 (CCS)
      +RES
      235 to 245 Ω
      1 (ECC) - 3 (CCS)
      -SET
      620 to 640 Ω
      1 (ECC) - 3 (CCS)
      CANCEL
      1510 to 1570 Ω
      1 (ECC) - 3 (CCS)
      Main switch off
      1 MΩ or higher
      1 (ECC) - 3 (CCS)
      Main switch on
      Below 2.5 Ω

      1. If the result is not as specified, replace the cruise control main switch assembly.

  1. Measure the resistance (for vehicles with vehicle-to-vehicle distance control mode).

    E155226E02

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 (ECC) - 3 (CCS)
      +RES
      235 to 245 Ω
      1 (ECC) - 3 (CCS)
      -SET
      620 to 640 Ω
      1 (ECC) - 3 (CCS)
      CANCEL
      1510 to 1570 Ω
      1 (ECC) - 3 (CCS)
      Main switch off
      1 MΩ or higher
      1 (ECC) - 3 (CCS)
      Main switch on
      Below 2.5 Ω
      3 (CCS) - 2 (R/N)
      Main switch on and mode switch on
      Below 2.5 Ω

      1. If the result is not as specified, replace the cruise control main switch assembly.

← INSPECTION (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →