2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT REAR SPEAKER SET (except 14 Speakers)

  1. E107214E19
    Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Component without harness connected
    (Rear Speaker Set)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    4 Ω

    If the result is not as specified, replace the speaker set.


INSPECT REAR SPEAKER SET (for 14 Speakers)

  1. E107214E19
    Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Component without harness connected
    (Rear Speaker Set)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    1.5 to 2.3 Ω

    If the result is not as specified, replace the speaker set.


INSPECT REAR NO. 3 SPEAKER ASSEMBLY (for 14 Speakers)
  1. When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.

    OK:
    Malfunction disappears.

    HINT:
    1. Connect all the connectors to the rear No. 3 speakers.
    2. When there is a possibility that either the right or left rear speaker is defective, inspect by interchanging the right one with the left one.
    3. Perform the inspection above on both LH and RH sides.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →