2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


CHECK OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloration or thinning.
    If the quality is visibly poor, replace the oil and filter (Click here).


INSPECT ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick low level mark and full level mark.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.


INSPECT OIL PRESSURE
  1. Remove the oil pressure sender gauge (Click here).

  1. A162458
    Install an oil pressure gauge with an adapter.

  1. Warm up the engine.

  1. Measure the engine oil pressure.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idle
    70 kPa (0.7 kgf/cm2, 10.1 psi) or higher
    2500 rpm
    220 kPa (2.2 kgf/cm2, 32 psi) or higher

    If the pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge and adapter.

  1. Install the oil pressure sender gauge (Click here).

← INSTALLATION (from Jan 2012)COMPONENTS (from Sep 2011) →