2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The circuit is necessary for the Automatic Sound Levelizer (ASL) built into the stereo component amplifier assembly.
Speed signals are received from the combination meter assembly and used for the ASL.
The ASL function automatically adjusts the sound volume in order to clear audio quality even when vehicle noise increases (as vehicle noise increases, the volume is turned up etc.).

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM

E195676E08

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMBINATION METER)
  1. Disconnect the F74 stereo component amplifier assembly connector and E7 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F74-17 (SPD) - F7-4 (+S)
    Always
    Below 1 Ω
    F74-17 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM)
  1. Reconnect the E7 combination meter assembly connector.

  1. E240104E10
    Check the input waveform.
    1. Connect an oscilloscope to terminal F74-17 (SPD) and body ground.

    2. Turn the engine switch on (IG).

    3. Turn a wheel slowly.

      Text in Illustration 
      *a
      Front view of wire harness connector
      (to Stereo Component Amplifier Assembly)

    4. I043789E07
      Check the signal waveform according to the condition(s) in the table below.
      Item
      Condition
      Measurement terminal
      F74-17 (SPD) - Body ground
      Tool setting
      5 V/DIV., 20 ms./DIV.
      Vehicle condition
      Driving at approx. 20 km/h (12 mph)

      OK:
      The waveform is displayed as shown in the illustration.

      HINT:
      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter (Sep 2011 – Dec 2011)Display Signal Circuit between Multi-display and Radio Receiver (from Jan 2012) →