2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Multi-display and Radio Receiver

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The display image signal from the multi-media module receiver assembly is sent to the multi-display assembly using a digital communication cable.

WIRING DIAGRAM

E245680E03

INSPECTION PROCEDURE


1. CHECK DIGITAL COMMUNICATION CABLE CONNECTOR
  1. Check if the digital communication cable connectors between the multi-media module receiver assembly and the multi-display assembly have any connection problems (Click here).

  1. Check that the screen display is normal.

    OK:
    Screen display is normal.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK MULTI-DISPLAY ASSEMBLY
  1. Replace the multi-display assembly with a new or normally functioning one (Click here).

  1. Check that the screen display is normal.

    OK:
    Screen display is normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE)


← Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter (from Jan 2012)Microphone Circuit between Microphone and Radio Receiver (from Jan 2012) →