2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the RHD and LHD.
  2. The procedures listed below are the LHD side.


1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

  1. B189607E01
    Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 4 claws to install the front passenger side knee airbag.

  1. Install the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

B182552
  1. Attach the 4 claws to install the No. 2 instrument panel under cover.


3. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

B180005
  1. Attach the 7 claws to install the lower instrument panel pad sub-assembly.

  1. Install the clip and screw.


4. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION

B182501
  1. Attach the 7 claws to install the No. 1 instrument panel finish panel cushion.


5. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


7. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →