INSTALLATION
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the same procedures for the RHD and LHD.
- The procedures listed below are the LHD side.
| 1.
INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY |
 |
- Connect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Attach the 4 claws to install the front passenger side knee airbag.
Install the 4 bolts.
-
Torque:
- 10 N*m{
102 kgf*cm
, 7 ft.*lbf
}
| 2.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
|
 |
Attach the 4 claws to install the No. 2 instrument panel under cover.
| 3.
INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
|
 |
Attach the 7 claws to install the lower instrument panel pad sub-assembly.
Install the clip and screw.
| 4.
INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION
|
 |
Attach the 7 claws to install the No. 1 instrument panel finish panel cushion.
| 5.
INSTALL FRONT DOOR SCUFF PLATE RH
|
 |
- HINT:
- Use the same procedures described for the LH side.
| 6.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 7.
CHECK SRS WARNING LIGHT |
 |
Check the SRS warning light (Click here).