2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the RHD and LHD.
  2. The procedures listed below are the LHD side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.


3. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

B180004E02
  1. Put protective tape around the No. 1 instrument panel finish panel cushion.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 7 claws and remove the No. 1 instrument panel finish panel cushion.


4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

B180005
  1. Remove the clip and screw.

  1. Detach the 7 claws and remove the lower instrument panel pad sub-assembly.


5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

B180656
  1. Detach the 4 claws and remove the No. 2 instrument panel under cover.


6. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

  1. B189606E01
    Remove the 4 bolts.

  1. Detach the 4 claws and remove the front passenger side knee airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →