2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Headlight Cleaner Motor and Relay Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit provides power to the headlight cleaner control relay.
The headlight cleaner control relay sends the signal from the switch, etc. to the headlight cleaner motor to operate the headlight cleaner system.

WIRING DIAGRAM

E158383E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG No. 1, H-LP CLR)
  1. Remove the ECU-IG No. 1 fuse from the main body ECU.

  1. Remove the H-LP CLR fuse from the engine junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω
    H-LP CLR fuse



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - BATTERY AND BODY GROUND)

  1. E139345E06
    Disconnect the A17 relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    3 (IG) - Body ground
    Engine switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (E) - Body ground
    Engine switch on (IG)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

  1. B172829E02
    Remove the headlight cleaner motor (Click here).

  1. Apply battery voltage to the headlight cleaner motor and check the operation of the headlight cleaner motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Headlight cleaner motor operation is normal



NG
REPLACE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (CLEANER MOTOR - CONTROL RELAY AND BATTERY)

  1. E125074E09
    Disconnect the cleaner motor connector.

  1. Disconnect the control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 6 (PB)
    Always
    Below 1 Ω
    2 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Headlight Cleaner Switch Circuit (from Jan 2012)Headlight Cleaner Motor and Relay Circuit (from Jan 2012) →