2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the oil control valve assembly.

  1. A165597E04
    Connect the battery positive (+) lead to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

    OK:
    Condition
    Specified Condition
    Battery positive (+) voltage is applied
    Valve moves in left arrow direction shown in the illustration
    Battery positive (+) voltage is cut off
    Valve moves in right arrow direction shown in the illustration

    Text in Illustration 
    *a
    Component without harness connected
    (Oil Control Valve)
    If the result is not as specified, replace the oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →