2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the camshaft timing oil control valve assembly.

  1. A267615E01
    Connect the positive (+) lead of the battery to terminal 1 and the negative (-) lead to terminal 2 and check the movement of the valve.

    OK:
    Condition
    Specified Condition
    Battery positive (+) voltage is applied
    Valve moves in left arrow direction shown in the illustration
    Battery positive (+) voltage is cut off
    Valve moves in right arrow direction shown in the illustration

    Text in Illustration 
    *a
    Component without harness connected
    (Camshaft Timing Oil Control Valve)
    If the result is not as specified, replace the camshaft timing oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be stored.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →