2011-2013 Land Cruiser · Service Manual Vehicle Interior

B1467/67 Rear Air Foot Duct Sensor Circuit on Driver Side

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The air duct temperature sensor LH*1 or RH*2 (for driver side) detects the duct temperature and sends the appropriate signals to the air conditioning amplifier assembly.
DTC Code
DTC Detection Condition
Trouble Area
B1467/67
An open or short in the air duct temperature sensor LH*1 or RH*2 circuit.
  1. Air duct temperature sensor LH*1
  2. Air duct temperature sensor RH*2
  3. Harness or connector (air duct temperature sensor LH)*1
  4. Harness or connector (air duct temperature sensor RH)*2
  5. Air conditioning amplifier assembly

HINT:
*1: for LHD
*2: for RHD


WIRING DIAGRAM

E156584E28
E156584E29

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (AIR DUCT TEMPERATURE SENSOR)
  1. Use the Data List to check if the air duct temperature sensor LH*1 or RH*2 (for driver side) is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Foot Duct Sensor (Rear D)
    Min.: -12.7°C (9.14°F)
    Max.: 76.55°C (169.79°F)
    Actual air duct temperature sensor (for driver side) displayed
    Open in the circuit: -12.7°C (9.14°F)
    Short in the circuit: 76.55°C (169.79°F)

    HINT:
    *1: for LHD
    *2: for RHD

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

2. CHECK AIR DUCT TEMPERATURE SENSOR

  1. E160938E01
    for LHD
    1. Remove the air duct temperature sensor LH (Click here).

  1. for RHD

    1. Remove the air duct temperature sensor RH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (+) - 2 (-)
    at 10°C (50°F)
    9.4 to 10.5 kΩ
    at 15°C (59°F)
    7.5 to 8.3 kΩ
    at 20°C (68°F)
    6.0 to 6.5 kΩ
    at 25°C (77°F)
    4.5 to 5.2 kΩ
    at 30°C (86°F)
    3.8 to 4.2 kΩ
    at 35°C (95°F)
    3.1 to 3.4 kΩ
    at 40°C (104°F)
    2.5 to 2.8 kΩ
    at 45°C (113°F)
    2.0 to 2.3 kΩ
    at 50°C (122°F)
    1.6 to 2.0 kΩ
    at 55°C (131°F)
    1.3 to 1.6 kΩ
    at 60°C (140°F)
    1.1 to 1.4 kΩ

    NOTICE:
    1. Touching the sensor even slightly may change the resistance value. Hold the connector of the sensor.
    2. When measuring the resistance, the sensor temperature must be the same as the ambient temperature.

    HINT:
    As the temperature increases, the resistance decreases (see the graph).
    If the resistance value is not as specified, replace the sensor.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD)
    B
    NG (for RHD)
    C



B
REPLACE AIR DUCT TEMPERATURE SENSOR LH (Click here)

C
REPLACE AIR DUCT TEMPERATURE SENSOR RH (Click here)
A


3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - AIR DUCT TEMPERATURE SENSOR)

  1. E156820E08
    for LHD
    1. Disconnect the K21 sensor connector.

    2. Disconnect the E35 amplifier connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      E35-25 (TR3) - K21-1 (+)
      Always
      Below 1 Ω
      E35-34 (SGND) - K21-2 (-)
      E35-25 (TR3) - Body ground
      Always
      10 kΩ or higher
      E35-34 (SGND) - Body ground

  1. E156820E09
    for RHD
    1. Disconnect the L12 sensor connector.

    2. Disconnect the E35 amplifier connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      E35-26 (TR4) - L12-1 (+)
      Always
      Below 1 Ω
      E35-12 (SG-9) - L12-2 (-)
      E35-26 (TR4) - Body ground
      Always
      10 kΩ or higher
      E35-12 (SG-9) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)


← B1458/58 Passenger Side Air Outlet Damper Control Servo Motor Circuit (from Jan 2012)B1467/67 Rear Air Foot Duct Sensor Circuit on Driver Side (from Jan 2012) →