2011-2013 Land Cruiser · Service Manual Vehicle Interior

B1458/58 Passenger Side Air Outlet Damper Control Servo Motor Circuit

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The front air mix damper servo motor (for front passenger side rear air flow) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the front air mix damper (for front passenger side rear air flow) to any position. As a result, the amount of air that has passed through the evaporator and is passing through the heater core is adjusted, and the temperature of the air blowing toward the rear passenger side is controlled.

HINT:
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.

DTC Code
DTC Detection Condition
Trouble Area
B1458/58
The air mix damper position does not change even if the air conditioning amplifier assembly operates the front air mix damper servo motor.
  1. Front air mix damper servo motor (for front passenger side rear air flow)
  2. Air conditioning harness assembly
  3. Air conditioning amplifier assembly

WIRING DIAGRAM

E161749E16
E161749E17

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (FRONT AIR MIX DAMPER SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Mix Servo Targ Pls (F&R P)
    Front air mix damper servo motor (for front passenger side rear air flow) target pulse /
    Min.: 5, Max.: 33 (for LHD)
    Min.: 13, Max.: 41 (for RHD)
    for LHD
    1. MAX COOL: 33 (pulse)
    2. MAX HOT: 5 (pulse)
    for RHD
    1. MAX COOL: 13 (pulse)
    2. MAX HOT: 41 (pulse)
    -

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

2. CHECK FRONT AIR MIX DAMPER SERVO MOTOR (OPERATION)
  1. for LHD:

    1. Replace the front air mix damper servo motor (for front passenger side rear air flow) (Click here).

  1. for RHD:

    1. Replace the front air mix damper servo motor (for front passenger side rear air flow) (Click here).

      HINT:
      Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1458 is not output.

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG (for LHD)
    C
    NG (for RHD)
    D



B
REPLACE FRONT AIR MIX DAMPER SERVO MOTOR (Click here)

C
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)

D
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)
A

REPLACE FRONT AIR MIX DAMPER SERVO MOTOR (Click here)


← B1458/58 Passenger Side Air Outlet Damper Control Servo Motor Circuit (Sep 2011 – Dec 2011)B1467/67 Rear Air Foot Duct Sensor Circuit on Driver Side (Sep 2011 – Dec 2011) →