2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE PINTLE HOOK ASSEMBLY (w/ Pintle Hook)
  1. Remove the pintle hook assembly (Click here).


2. REMOVE SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)
  1. Remove the spare wheel carrier sub-assembly (Click here).


3. REMOVE REAR QUARTER PANEL MUDGUARD LH

B180882
  1. Remove the clip.

  1. Using a T30 "TORX" socket, remove the 6 screws and mudguard.


4. REMOVE REAR QUARTER PANEL MUDGUARD RH

B180883
  1. Remove the clip.

  1. Using a T30 "TORX" socket, remove the 7 screws and mudguard.


5. REMOVE REAR NO. 1 BUMPER PLATE
  1. Put protective tape around the bumper plate.

  1. Detach the 20 claws and remove the bumper plate.

    B188258E01


6. REMOVE REAR BUMPER COVER

HINT:
For the rear bumper cover with tire carrier, use the procedures described below.

  1. Put protective tape around the bumper cover.

    B188259E01

  1. Open the tail gate and remove the 4 clips.

    B188260

  1. Close the tail gate.

  1. Remove the 7 bolts, 6 screws and 2 clips.

  1. w/o TOYOTA Parking Assist-sensor System, w/o Rear Fog Light:
    Detach the 14 claws and remove the bumper cover.

  1. w/ TOYOTA Parking Assist-sensor System or w/ Rear Fog Light:
    Detach the 14 claws, disconnect the No. 2 frame wire connector and remove the bumper cover.

    B188261


7. REMOVE REAR BUMPER ARM BRACKET LH

B181013
  1. Disconnect the connector.

  1. Remove the 2 bolts and bumper arm bracket.


8. REMOVE ELECTRICAL KEY ANTENNA

  1. B180456
    Remove the 2 screws and antenna.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →