2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE PINTLE HOOK ASSEMBLY (w/ Pintle Hook)
  1. Remove the pintle hook assembly (Click here).


2. REMOVE SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)
  1. Remove the spare wheel carrier sub-assembly (Click here).


3. REMOVE REAR QUARTER PANEL MUDGUARD LH

B180882
  1. Remove the clip.

  1. Using a T30 "TORX" socket, remove the 6 screws and mudguard.


4. REMOVE REAR QUARTER PANEL MUDGUARD RH

B180883
  1. Remove the clip.

  1. Using a T30 "TORX" socket, remove the 7 screws and mudguard.


5. REMOVE REAR NO. 1 BUMPER PLATE
  1. Put protective tape around the rear No. 1 bumper plate.

  1. Detach the 20 claws and remove the rear No. 1 bumper plate.

    B188258E02

    Text in Illustration 
    *1
    Protective Tape
    -
    -


6. REMOVE REAR BUMPER COVER

HINT:
For the rear bumper cover with tire carrier, use the procedures described below.

  1. Put protective tape around the rear bumper cover.

    B302184E01

    Text in Illustration 
    *1
    Protective Tape
    -
    -

  1. Open the tail gate and remove the 4 clips.

    B302185

  1. Close the tail gate.

  1. Remove the 7 bolts, 6 screws and 2 clips.

  1. Detach the 14 claws and remove the rear bumper cover.

    B302186

  1. w/ TOYOTA Parking Assist-sensor System or w/ Rear Fog Light:
    Disconnect the No. 2 frame wire connector.


7. REMOVE REAR BUMPER ARM BRACKET LH

  1. B181013
    Disconnect the connector.

  1. Remove the 2 bolts and rear bumper arm bracket LH.


8. REMOVE ELECTRICAL KEY ANTENNA

  1. B180456
    Remove the 2 screws and antenna.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →