Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Seat Position Memory System)
Front Power Seat does not Operate with Front Power Seat Switch
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
When a signal is input into the position control ECU, the ECU manages the signals received from the front power seat switch LH, and operates each motor. When 2 or more signals are input, the motors only operate when the signals are from the slide switch and reclining switch. WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT FUSE (FR P/SEAT LH, FR P/SEAT RH, ECU-B2)
Remove the FR P/SEAT LH*1, FR P/SEAT RH*2 and ECU-B2 fuses from the main body ECU.
HINT:
*1: for LHD
*2: for RHD
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LHD
Tester Connection
Condition
Specified Condition
FR P/SEAT LH fuse
Always
Below 1 Ω
ECU-B2 fuse
Always
Below 1 Ω
for RHD
Tester Connection
Condition
Specified Condition
FR P/SEAT RH fuse
Always
Below 1 Ω
ECU-B2 fuse
Always
Below 1 Ω
NG
OK
2. CHECK HARNESS AND CONNECTOR (POSITION CONTROL ECU AND SWITCH - BATTERY AND BODY GROUND)
Disconnect the c14*1, c15*1 or c26*2, c27*2 switch connectors.
HINT:
*1: for LHD
*2: for RHD
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for LHD
Tester Connection
Condition
Specified Condition
c14-5 (+B) - Body ground
Always
11 to 14 V
c15-8 (SYSB) - Body ground
Always
11 to 14 V
for RHD
Tester Connection
Condition
Specified Condition
c26-5 (+B) - Body ground
Always
11 to 14 V
c27-8 (SYSB) - Body ground
Always
11 to 14 V
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LHD
Tester Connection
Condition
Specified Condition
c14-1 (GND) - Body ground
Always
Below 1 Ω
for RHD
Tester Connection
Condition
Specified Condition
c26-1 (GND) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE POSITION CONTROL ECU AND SWITCH (Click here )