2011-2013 Land Cruiser · Service Manual Vehicle Interior

Front Power Seat does not Operate with Front Power Seat Switch

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

When a signal is input into the position control ECU, the ECU manages the signals received from the front power seat switch LH, and operates each motor. When 2 or more signals are input, the motors only operate when the signals are from the slide switch and reclining switch.

WIRING DIAGRAM

B183729E01

INSPECTION PROCEDURE


1. INSPECT FUSE (FR P/SEAT LH, FR P/SEAT RH, ECU-B2)
  1. Remove the FR P/SEAT LH*1, FR P/SEAT RH*2 and ECU-B2 fuses from the main body ECU.

    HINT:
    *1: for LHD
    *2: for RHD

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    FR P/SEAT LH fuse
    Always
    Below 1 Ω
    ECU-B2 fuse
    Always
    Below 1 Ω
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    FR P/SEAT RH fuse
    Always
    Below 1 Ω
    ECU-B2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (POSITION CONTROL ECU AND SWITCH - BATTERY AND BODY GROUND)
B128942E04
  1. Disconnect the c14*1, c15*1 or c26*2, c27*2 switch connectors.

    HINT:
    *1: for LHD
    *2: for RHD

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    c14-5 (+B) - Body ground
    Always
    11 to 14 V
    c15-8 (SYSB) - Body ground
    Always
    11 to 14 V
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    c26-5 (+B) - Body ground
    Always
    11 to 14 V
    c27-8 (SYSB) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    c14-1 (GND) - Body ground
    Always
    Below 1 Ω
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    c26-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POSITION CONTROL ECU AND SWITCH (Click here)


← DATA LIST / ACTIVE TEST (from Sep 2011)Front Power Seat does not Operate with Front Power Seat Switch (from Jan 2012) →