2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2769 Tilt Sensor Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Sep 2011

DESCRIPTION

The yaw rate sensor conducts a self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
If a malfunction is detected in the CSIF-CSIF line, the certification ECU (smart key ECU assembly) stores this DTC.
DTC Code
DTC Detection Condition
Trouble Area
B2769
After a normal/trouble signal is output from the yaw rate sensor as the result of self-diagnosis, either of the following malfunctions is detected:
  1. The CSIF-CSIF line circuit is open.
  2. Reception of signals other than a normal/trouble signal.
  1. Yaw rate sensor
  2. Certification ECU (Smart key ECU assembly)
  3. Harness or connector

WIRING DIAGRAM

B176605E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - YAW RATE SENSOR)
B176764E02
  1. Disconnect the E30 ECU connector.

  1. Disconnect the E50 sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E30-21 (CSIF) - E50-5 (CSIF)
    Always
    Below 1 Ω
    E30-21 (CSIF) or E50-5 (CSIF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK YAW RATE SENSOR (OPERATION)
  1. Temporarily replace the yaw rate sensor that has a tilt determining function with a new or normally functioning one (Click here).

  1. Check that the system operates normally.

    OK:
    DTC B2769 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (YAW RATE SENSOR IS FAULTY)


← B2768 Tilt Sensor Internal Circuit Malfunction (from Sep 2011)B276A Short to GND in Tilt Sensor Signal Circuit (from Sep 2011) →