B276A Short to GND in Tilt Sensor Signal Circuit
Diagnostic trouble codes · Vehicles built from Sep 2011
DESCRIPTION
The yaw rate sensor conducts a self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).This DTC is stored when terminal CSIF of the yaw rate sensor has not received a signal for 5 seconds or more.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B276A |
After normal/trouble signal is output from the yaw rate sensor as result of self-diagnosis, the following malfunction is detected: Terminal CSIF of the yaw rate sensor has not received signal for 5 seconds or more |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS OR CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - YAW RATE SENSOR) |
![]() ![]() |
Disconnect the E30 ECU connector.
Disconnect the E50 sensor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E30-21 (CSIF) - E50-5 (CSIF)
Always
Below 1 Ω
E30-21 (CSIF) or E50-5 (CSIF) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK YAW RATE SENSOR (OPERATION) |
Temporarily replace the yaw rate sensor that has a tilt determining function with a new or normally functioning one (Click here).
Check that the system operates normally.
- OK:
- DTC B276A is not output.
|
|
||||
| OK | ||
| ||

