2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2764 Short to GND in Intrusion Sensor Signal Circuit

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

  1. The intrusion sensor conducts a self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
    This DTC is stored when terminal IOUT of the intrusion sensor has not received a signal for 5 seconds or more.
DTC Code
DTC Detection Condition
Trouble Area
B2764
After normal/trouble signal is output from the intrusion sensor as result of self-diagnosis, the following malfunction is detected:
Terminal IOUT of the intrusion sensor has not received signal for 5 seconds or more.
  1. Intrusion sensor
  2. Map light assembly
  3. Certification ECU (Smart key ECU assembly)
  4. Harness or connector

WIRING DIAGRAM

B187422E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MAP LIGHT - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] AND BODY GROUND)
B188703E01
  1. Disconnect the R7 light connector.

  1. Disconnect the E30 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R7-12 (IOUT) - E30-4 (IOUT)
    Always
    Below 1 Ω
    R7-12 (IOUT) or E30-4 (IOUT) - Body ground
    Always
    10 kΩ or higher
    R7-3 (GND5) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK INTRUSION SENSOR (OPERATION)
  1. Temporarily replace the intrusion sensor with a new or normally functioning sensor (Click here).

  1. Check if DTC B2764 is not output.

    OK:
    DTC B2764 is not output.



NG
Go to step 3
OK

END (INTRUSION SENSOR IS FAULTY)

3. CHECK MAP LIGHT ASSEMBLY (OPERATION)
  1. Temporarily replace the map light with a new or normally functioning one (Click here).

  1. Check if DTC B2764 is not output.

    OK:
    DTC B2764 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (MAP LIGHT ASSEMBLY IS FAULTY)


← B2762 Intrusion Sensor Signal Circuit Malfunction (from Jan 2012)B2764 Short to GND in Intrusion Sensor Signal Circuit (from Jan 2012) →